Table of Contents
Advertisement
12 BRAKE SYSTEM
80
–
Move the brake reservoir mounted on the handlebar to a hori-
zontal position.
–
Remove screws
–
Take off cover
V01453-11
–
Press the brake piston back into the basic position and
ensure that brake fluid does not flow out of the brake fluid
reservoir; extract some if necessary.
–
Press together brake linings
brake caliper.
F00417-10
–
Clean the brake caliper and spring plate.
–
Ensure that the spring plate is correctly positioned.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
F00418-10
–
Position the new brake linings
toward the pistons.
The spring plate is seated correctly in the brake caliper.
Info
Always change the brake linings in pairs.
F00419-10
–
Position the brake caliper. Mount screws
2
ers
but do not tighten yet.
The brake linings are correctly positioned.
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Fix the hand brake lever in the activated position.
The brake caliper straightens.
–
Tighten screws
F00404-10
Guideline
Screw, front
brake caliper
–
Remove the locking piece of the hand brake lever.
3
.
4
5
with membrane
.
6
and remove them from the
6
in the guides and press
1
1
.
M10
45 Nm (33.2 lbf ft)
with wash-
®
Loctite
243™
Advertisement
Table of Contents
