Adjusting The Throttle Cable Play; Carburetor - Idle Setting (Tc 50) - KTM TC 50 2020 Owner's Manual

15 TUNING THE ENGINE
15.3
15.4
106

Adjusting the throttle cable play

F02239-10
400192-11
Carburetor – idle setting (TC 50)
K01224-10
Preparatory work
–
Check the installation position of the throttle grip. (
–
Remove the seat. ( p. 62)
–
Remove the left side cover. (
–
Remove the right side cover. (
–
Turn the knurled screw on the fuel tap all the way clockwise.
–
Remove the fuel tank.
–
Check the throttle cable routing. (
Main work
–
Move the handlebar to the straight-ahead position.
–
1
Push back sleeve .
–
Ensure that the throttle cable sleeve is pushed all the way
2
into barrel adjuster .
–
3
Loosen nut .
–
2
Turn barrel adjuster so that there is play
cable at the throttle grip.
Guideline
Throttle cable play
–
3
Tighten nut .
–
1
Slide on sleeve .
Finishing work
–
Install the fuel tank. (
–
Install the left side cover. (
–
Install the right side cover. (
–
Mount the seat. ( p. 62)
–
Check the throttle cable play. (
The idle setting of the carburetor has a big influence on the
starting behavior, stable idle speed, and the response to throttle
opening. This means that an engine with a correctly set idle
speed will be easier to start than one with an incorrectly set idle
speed.
Info
The carburetor and its components are subject to
increased wear caused by engine vibration. Wear can
result in malfunctioning.
The idle speed is adjusted using the idle speed adjusting
1
screw .
The idle mixture is adjusted using the idle air adjusting screw
p. 58)
p. 55)
( p. 52)
p. 75)
A
in the throttle
3 ... 5 mm (0.12 ... 0.2 in)
p. 53)
p. 59)
p. 56)
p. 105)
p. 105)
2
.