Sony MZ-R55 Operating Instructions Manual page 26

5
Repeat step 4 and enter all characters
of the label name.
6
Keep pressing the p for 2 seconds or
more.
The track or disc is labeled.
Labeling a track during playback
1
Insert a disc and play the track you
want to label.
2
Press DISPLAY for 2 seconds or
more.
" : Name" flashes in the display.
3
Press p.
The track is ready to be labeled.
4
Follow steps 4 to 6 of "Labeling a disc
during stop" above.
Labeling a track or a disc during
recording
1
Press DISPLAY for 2 seconds or more
during recording.
" : Name" flashes in the display.
2
To label a track, press p.
To label a disc, turn the control to
= or (•+ until "
flashes in the display, then press p.
3
Follow steps 4 to 6 of "Labeling a disc
during stop" above.
To cancel labeling, press TRACK MARK.
Note
If the recording is stopped while labeling
a track or a disc, or if the next track begins
on the recording source while labeling a
track, the labeling that is input up to that
point is entered automatically.
26-
GB
Available characters
• Capital and small letters of the English
• Numbers 0 to 9
• ! " # $ % & ( ) * . ; < = > ?
To relabel recordings
Follow the steps corresponding to the
labeling method until the disc or track is
ready to be labeled. Enter a new character
over the one you want to change, then
press EDIT/ENTER (keep pressing p for
2 seconds or more on the remote control).
Notes
•You cannot relabel premastered MDs or
label MDs that have not been recorded.
•The recorder is able to display, but cannot
label using, Japanese "Katakana"
characters.
: Name"
alphabet
@ _ ` + – ' , / : _ (space)