Kohler K-29777-PA-0 Homeowner's Manual page 10

Enable/Disable Automatic Features
NOTE: The cover open/close, deodorizer, automatic flush, nightlight, and automatic UV cleaning features come enabled
from the factory.
Cover Open/Close
When enabled, the seat cover automatically opens when the toilet is approached. The seat cover will automatically
close 2 minutes after the toilet has been used.
Press and hold the Flush icon on the control panel until the nightlight blinks three times.
Press and hold the "Cover" icon on the remote control until the "Massage" LEDs turn ON. Release the icon, then press
to change the setting.
The first "Massage" LED will be ON when the sensor is set to short distance, the second LED ON for middistance, and
the third LED for long distance. All "Massage" LEDs will be OFF when the feature is disabled.
Press the "Stop" icon to exit setup mode.
Deodorizer
When enabled, the deodorizer automatically activates while the toilet is in use.
Press and hold the Flush icon on the control panel until the nightlight blinks three times.
Press and hold the "Deodorizer" icon on the remote control until the "Water Temp" LEDs turn ON. Release the icon,
then press to change the setting.
A short beep and "Water Temp" LEDs ON indicate that the feature is enabled. A long beep and "Water Temp" LEDs
OFF indicate that the feature is disabled.
Press the "Stop" icon to exit setup mode.
Automatic Flush
When enabled, the toilet will automatically flush after the user stands up, lowers the cover, or approximately 60
seconds after the front of the toilet last senses motion.
Press and hold the Flush icon on the control panel until the nightlight blinks three times.
Press and hold the "Full Flush" icon on the remote control until the "Rear" LEDs turn ON. Release the icon, then press
to change the setting.
A short beep and "Rear" LEDs ON indicate that the feature is enabled. A long beep and "Rear" LEDs OFF indicate
that the feature is disabled.
Press the "Stop" icon to exit setup mode.
Automatic Seat/Water Temperature
When enabled, the seat temperature and water temperature automatically adjust according to the room temperature.
Press and hold the Flush icon on the control panel until the nightlight blinks three times.
Press and hold the "Water Temp" icon on the remote control until the "Water Temp" and "Seat Temp" LEDs turn ON.
Release the icon, then press to change the setting.
A short beep and "WaterTemp" and "Seat Temp" LEDs ON indicate that the feature is enabled. A long beep and icon
LEDs OFF indicate that the feature is disabled.
Press the "Stop" icon to exit setup mode.
1486085-5-C
10 Kohler Co.