California Energy Commission Battery Charging Testing Instructions - VTech CS6429 User Manual

Appendix

California Energy Commission battery charging testing instructions

This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging, will
be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are
plugged with charged batteries.
While you press and hold /FIND HANDSET, plug the telephone base power adapter back to the
2.
power outlet.
After about 20 seconds, when the IN USE light starts flashing, release /FIND HANDSET and then
3.
press it again within 2 seconds.
When the phone successfully enters the CEC battery charging testing mode, the IN USE light
turns off and all handsets display 1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS #
ON HANDSET alternately.
When the phone fails to enter this mode, repeat Step 1 through
Step 3 above.
The telephone base will be powered up as normal if you fail to press /FIND HANDSET
within 2 seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base adapter from the power outlet, then plug it back in. Then the telephone
base is powered up as normal.
2. Press and hold
IN USE light on the telephone base turns on.
#
(pound key) on the handset. The handset shows REGISTERING..... PLEASE WAIT. The
3. Press
handset shows HANDSET REGISTERED and you hear a beep when the registration process
completes. This process takes about 60 seconds.
If the registration fails, the handset shows REGISTRATION FAILED and then 1.PRESS
•
FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON HANDSET alternately. Remove
the handset from the telephone base and place it back in. Repeat Steps1 and 2 again.
• To reset the telephone, unplug the power and the battery for a few seconds then plug
them back in.
• Only one handset can register to the telephone base at a time.
/FIND HANDSET on the telephone base for about four seconds until the red
67