California Energy Commission Battery Charging Testing Instructions - VTech CS6729 User Manual

Appendix

California Energy Commission battery charging testing instructions

This telephone meets the California Energy Commission (CEC) regulations for energy consumption. It is not necessary
to activate the energy conserving mode during normal usage, unless you want to charge the battery only and disable all
telephone functions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged with charged
batteries before proceeding.
2. While you press and hold /FIND HANDSET, plug the telephone base power adapter back to the power outlet.
3. After about 20 seconds, when the IN USE light starts flashing, release /FIND HANDSET and then press it again within
2 seconds.
The process takes up to one minute to complete. When the phone successfully enters the CEC battery charging testing
mode, the IN USE light turns off and all handsets display To register HS... and ...see manual alternately.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above. The telephone base will be powered up as
normal if you fail to press /FIND HANDSET within 2 seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, and then plug it back in. Then the telephone base is
powered up as normal.
2. Register your handsets back to the telephone base. Refer to Register a handset.
74