Mercedes-Benz B-Class Electric Drive 2014 Operator's Manual page 246

Features
244
remote fault diagnosis can be started, the
Request for vehicle diagnosis Request for vehicle diagnosis
received. Start vehicle diagnosis? received. Start vehicle diagnosis?
message appears in the display.
Confirm the message with
X
When the Vehicle Vehicle diagnosis:
X
start ignition start ignition
the key to position 2 in the ignition lock
( page 127).
Y
When the Please Please follow
X
tions received by phone and move tions received by phone and move
your vehicle to a safe position your vehicle to a safe position
message appears, follow the customer ser-
vice representative's instructions.
The message in the display disappears.
If you select
nosis is canceled completely.
The vehicle operating state check begins.
You will see the
activated. activated.
When the diagnosis is completed, the
vehicle vehicle diagnostics diagnostics data
nection may be interrupted during nection may be interrupted during
data transfer) data transfer)
vehicle data can now be sent to the Customer
Assistance center.
Press OK OK to confirm the message.
X
The voice connection with the Customer
Assistance Center is terminated.
You will see the
Transferring data... Transferring data...
The vehicle data is sent to the Customer
Assistance Center.
Depending on what the customer service rep-
resentative agreed with you, the voice con-
nection is re-established after the transfer is
complete. If necessary, you will be contacted
at a later time by another means, e.g. by e-
mail or phone.
Another function of the remote fault diagno-
sis is the transfer of service data to the Cus-
tomer Assistance Center. If a service is over-
due, the COMAND display shows a message
about various special offers at your work-
shop.
Yes Yes.
diagnosis: Please
message appears, turn
follow the the instruc‐ instruc‐
Cancel Cancel the remote fault diag-
Vehicle diagnosis Vehicle diagnosis
message.
data (Voice (Voice con‐
message appears. The
Vehicle Diagnosis: Vehicle Diagnosis:
message.
Information on the data stored in the vehicle
( page 26).
Y
Information on Roadside Assistance
( page 21).
Y
Downloading routes
Please
Downloading routes allows you to transfer
and save predefined routes in the navigation
system. To do this, an SD memory card must
be inserted into the COMAND system. If no
SD memory card is inserted, you must insert
the card into the card slot on the COMAND
system before saving.
A route can be prepared and sent either by a
customer service representative or via the
mbrace portal on the Internet.
Each route can include up to 20 way points.
Once a route has been received by the navi-
gation system, you will see the
name> has name> has been
Do Do you you want want to to start
Send Send
message in the COMAND display. The route is
con‐
saved to the SD memory card.
To start route guidance: select
X
An overview of the route is shown in the
display.
i
If you select
called up later via the navigation menu.
Select Start Start.
X
Route guidance is started.
i
Downloaded and saved data can be called
up again in COMAND.
You can find further information in the sep-
arate COMAND Operating Instructions.
Speed alert
You can define the upper speed limit, which
must not be exceeded by the vehicle.
If this selected speed is exceeded by the vehi-
cle, a message will be sent to the Customer
Assistance Center. The Customer Assistance
Center then forwards this information to you.
You can select the way in which you receive
this information beforehand. Possible options
<route <route
been saved saved to to memory memory card.
start route route guidance?
No, the saved route can be No
card.
guidance?
Yes. Yes