Mercedes-Benz B-Class Electric Drive 2014 Operator's Manual page 141

charge current. If necessary, lower the set
charge current or use another power
socket.
You can set a limit for the values of the charge
current used in charging the high-voltage bat-
tery. This acts as a means of preventing the
power supply from overloading. You can set
this limit by using the controls on the charging
cable or in the on-board computer's menu.
Only set the maximum charge current in the
on-board computer menu if there are no
charge current settings on the charging
cable.
The default standard value is the minimum
charge current setting. This corresponds to
the minimum available charge current from
the power supply.
i
The value of the maximum setting and the
adjustment values may vary depending on
the country.
Before charging the high-voltage battery,
have the maximum permissible charge cur-
rent for the relevant power socket checked by
an electrician.
To adjust the setting: press button ?
X
repeatedly until the desired setting is selec-
ted in display =.
Two LEDs are flashing: minimum setting
R
All LEDs are flashing: maximum setting
R
Information about the charging time
( page 311)
Y
If, after the charging process, the charging
cable is:
left connected to the power socket, the
R
currently selected values will be used for
the next charging process.
removed from the power socket, the values
R
will be reset to the minimum setting for the
next charging process. You may then need
to reset the values of the maximum charge
current.
i
If more time than usual is required when
charging the high-voltage battery, check
the maximum charge current setting using
Charging the high-voltage battery
the controls on the charging cable or in the
on-board computer's menu.
Connecting the charging cable
To open the charge socket flap
:
Tire pressure table
;
Vehicle charge socket cover
=
Fastener
?
Vehicle socket
A
Warning sticker
B
Shift the DIRECT SELECT lever to position
X
P.
Switch the ignition off.
X
Press the charge socket flap in the direc-
X
tion of arrow :.
The charge socket flap swings up.
Slide fastener ? to the right.
X
Vehicle charge socket cover = is open.
Insert the power supply plug into the elec-
X
trical outlet to the stop.
Insert the charging cable connector into
X
vehicle socket A to the stop.
The high-voltage battery is being charged.
139
Z