Mercedes-Benz B-Class Electric Drive 2014 Operator's Manual page 142

Charging the high-voltage battery
140
i The vehicle must not be moved while the
charging cable is connected or during
charging.
i
Depending on the temperature, the
engine cooling system and battery cooling
system may audibly switch on when the
charging cable is connected or during the
charging process.
Removing the charging cable
When the charge level display reaches 100%,
the battery is fully charged (
! Make sure the charging cable has been
disconnected from the vehicle socket
before starting a journey. The vehicle or
charging cable may otherwise be damaged
when you drive off.
When the battery is charged:
Press and hold button C on the charging
X
cable connector and remove the charging
cable from vehicle socket A.
Close vehicle socket cover =.
X
Close the charge socket flap.
X
Remove the charging cable from the elec-
X
trical outlet.
Stow the charging cable safely in the vehi-
X
cle ( page 138).
Y
Charging the high-voltage battery at
the charging station
General notes
Pay attention to the "Important safety notes"
(
Y
Charging communication at a charging
station
The charging station first has to be activated
before you can charge at a charging station.
You can activate the charging station by using
page 174).
Y
an RFID card or via telephone activation.
Observe the on-site operator instructions for
the charging station.
When the vehicle is connected to the charging
station, information and details on technical
parameters are exchanged. It can thus take
up to 30 seconds for the charging process to
begin.
Connecting the charging cable
:
;
page 134).
To open the charge socket flap
Tire pressure table