Table of Contents
Advertisement
Fingerprints
The addition of the optional fingerprint reader to your
system allows you to turn areas on and off or to open a door
simply by presenting your fingerprint to the reader. The
following steps we help you to get the best performance
from your fingerprint reader.
1) When adding or enrolling fingerprints it is is important
to place and hold your finger in the correct position while
the system records the credential. Your finger should be
placed so that the pad is making full contact with the
sensor. Do not use your fingertip.
2) Always try to present your finger in the same posistion as
you did when it was enrolled. Use the raised dimple on the
reader surface as a guide. People with smaller fingers may
find this difficult at first but with practice even they will be
able to use the reader.
3) The reader will vibrate as soon as it has completed
reading your fingerprint. Once you feel the vibrations you
should remove your finger.
4) If the reader fails on the first attempt, remove your finger
and wait for the large blue guide indicator to come on
before trying again. Whenever the reader is busy working
you may see the following screen on the keypad. Wait for a
few seconds before trying again.
Fr9 Unit Busy. Please try
later.
Press OK or MENU
5) In some cases the unit may not be able to read a finger
because the finger is cut or damaged by other means.
Extremely wet or dry fingers may also cause read errors but
these are rare. In this case you should revert to using your
PIN number on the standard keypad.
Figure 3: CM729B Fingerprint Reader
Bosch Security Systems 3/23 BLCC610U
Access > Fingerprint >
Add Fingerprint
This menu allows a master user to add a new fingerprint
for users that have been assigned to the same area(s) as
the Master user.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [8] + [0].
A list of users will display on the keypad.
2. Use the [] and [] keys to select the user that you
want to add a a fingerprint for, then press [OK] to
select.
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press
3. The system will prompt you to present the finger
to the reader. If more than 1 fingerprint reader is
installed then the system will prompt you to select
the reader to learn from.
Fp9 Keypad 9 Name
Fp10 Keypad 10 Name
Fp11 Keypad 11 Name
Press
4. You must hold your finger on the reader without
moving until you hear a confirmation beep which
could take up to 5 seconds.
Position Finger for Ur1
John Smith at Fp9
Press OK or MENU
Only one fingerprint can be assigned to each user.
i
To change a fingerprint for an existing user, you will
Note
need to first delete the old fingerprint first.
Access > Fingerprint >
Delete Fingerprint
This menu allows a Master user the ability to delete a
fingerprint for those users that have been assigned to the
same area(s) as the Master user.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [8] + [1].
A list of users will display on the keypad.
2. Use the [] and [] keys to select the user who's
fingerprint you want to delete, then press [OK] to
select.
Solution 6000
User Guide
MENU 1-8-0
OK or MENU
OK or MENU
MENU 1-8-1
17
Advertisement
Table of Contents
