Table of Contents
Advertisement
Note: The top edge of the outer side cover must be clear of the top cover.
5. Pull up to release the bottom edge of the outer side cover.
6. Put the cover in a safe place.
Outer Side Cover Replacement (Model 6E4)
To replace the outer side cover, do the following:
1. Place the bottom edge retaining slot of the outer side cover over the outer edge of
the system base.
2. Pivot the outer side cover up toward the top of the system.
3. Align the 4 top locking tabs slots, located on the outer side cover, with the locking
tabs, located on the bottom side of the top cover.
4. Push the cover in. When correctly seated, push the outer side cover forward, toward
the front of the chassis. The four top locking tabs are now locked in place.
5. Align the thumbscrew, located on the rear of the outer side cover, with the screw
hole located on the back of the chassis.
6. Tighten the thumbscrew.
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
362
1 Model 6E4
2 Outer Side Cover Locking Tab Slot
3 Outer Side Cover
4 Cover Retaining Slot
5 Thumbscrew
Advertisement
Table of Contents
