IBM eserver 630 6C4 Service Manual page 354

Setup Remote IPL (Initial Program Load)
This option allows you to enable and set up the remote startup capability of your
system unit. You must first specify the network parameters.
Network Parameters
1. IP Parameters
2. Adapter Parameters
3. Ping Test
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Selecting the IP (Internet Protocol) Parameters option displays the following menu.
IP Parameters
1. Client IP Address
2. Server IP Address
3. Gateway IP Address
4. Subnet Mask
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
To change IP parameters, type the number of the parameters for which you want to
change the value.
Attention:
gateway IP address to [0.0.0.0].
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
334
[000.000.000.000]
[000.000.000.000]
[000.000.000.000]
[255.255.255.000]
If the client system and the server are on the same subnet, set the
X = eXit System Management Services
X = eXit System Management Services