Table of Contents
Advertisement
Table 6. Service Processor Error Codes. (continued)
Error Code Description
4066 0130 Memory extender 0 on processor card 2 Processor card,
4066 0131 Memory extender 2 on processor card 2 Processor card,
4066 0A03 Reboot message on VPD channel 3
processor card 1. Reboot is necessary
for run-time array gard to take effect.
4066 0A04 Reboot message on VPD channel 4
processor card 2. Reboot is necessary
for run-time array gard to take effect.
4066 0B00 I/O slot 0, I/O port 0 (problem outside
the system unit)
4066 0B01 I/O slot 0, I/O port 1 (problem outside
the system unit)
4066 0B02 I/O slot 0, I/O port 2 (problem outside
the system unit)
4066 0B03 I/O slot 0, I/O port 3 (problem outside
the system unit)
4066 0BF0 I/O slot 0, I/O port x (problem outside
the system unit)
4066 0CA5 Invalid processor configuration
4066 0CA6 No usable memory left in the system.
The system must be rebooted.
4066 0CA9 Incorrect/incompatible memory DIMMs
are installed.
4066 0CAA System memory exceeds the limit for
this system type and model.
4066 0EA0 MOPS service processor code error.
4066 0EA1 Operating system code on main
processor
Action/
Possible Failing FRU
Location: U0.1-P1-C2
Location: U0.1-P1-C2
Reboot the system in slow mode. Run
diagnostics, then go to "MAP 0235:
System Array Self-Repair Problem
Resolution" in the RS/6000 Eserver
pSeries Diagnostic Information for
Multiple Bus Systems .
Reboot the system in slow mode. Run
diagnostics, then go to "MAP 0235:
System Array Self-Repair Problem
Resolution" in the RS/6000 Eserver
pSeries Diagnostic Information for
Multiple Bus Systems .
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Check that the processor cards are
properly installed and configured.
Go to "MAP 1240: Memory Problem
Resolution" on page 73.
Check that the memory DIMMs are
properly configured, and are the right
type for the system.
Remove the memory DIMMs until the
memory does not exceed the limit for
this system type and model.
1. Check for system firmware updates.
2. Call service support.
1. Check for operating system code
updates.
2. Call service support.
Chapter 5. Error Code to FRU Index
191
Advertisement
Table of Contents
