IBM eserver 630 6C4 Service Manual page 149

Table 1. Service Processor Checkpoints (continued)
Checkpoint Description
9116 Load system data areas
(NACA/PACA)
9117 Start system IPL program
9119 Waiting for VPD collection to
complete
9184 Firmware image being loaded into
service processor's control storage
during firmware update.
91C4 Flash update pending, either a
firmware update or hypervisor
dump.
91FF Control being handed to system
processor from service processor
9200 Scan interface BATs
9300 Logic BIST
9301 Scanned ABIST
9302 Dedicated ABIST
9303 Dedicated ABIST array fuse repair
calculation
9380 Built-in-self-test (BIST)
9400 Service processor is requesting
system flush
9410 Service processor is issuing request
to start instruction execution
9411 Service processor is issuing request
to stop instruction execution
9420 Service processor is issuing request
to start system clocks
Action/
Possible Failing FRU
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
1. Remove, then reapply power to
the system. If the service
processor enters recovery
mode, (indicated by A1FD 0000
in the display), attempt to
update the firmware again in
recovery mode. If the service
processor comes up to the OK
prompt, try again to update the
firmware using the service
processor menus.
2. Call service support.
Note: This checkpoint may be
displayed during the firmware
update process. The checkpoint
may be displayed for a long period
of time during the process. If
process does not complete, the
system may be hung.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
See note 2 on page 133.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
See note 1 on page 132.
Chapter 4. Checkpoints
129