Table of Contents
Advertisement
Step 1540-12
The system is working correctly with this configuration. One of the disk drives that you
removed from the disk drive may be defective.
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn off the power and remove the power cords.
3. Install a disk drive in the disk drive backplane.
4. Plug in the power cords and wait for the OK prompt to display on the operator panel
display.
5. Turn on the power.
6. After the word keyboard is displayed, press the number 5 key on either the directly
attached keyboard or on an ASCII terminal keyboard.
7. Enter the appropriate password if you are prompted to do so.
Is the "Please define the System Console" screen displayed?
No
Yes
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
112
Exchange the FRUs that have not been exchanged, in the following order:
1. Last disk drive installed
2. Disk drive backplane
Repeat this step until the defective FRU is identified or all the FRUs have been
exchanged.
If the symptom did not change and all the FRUs have been exchanged, call
service support for assistance.
If the symptom has changed, check for loose cards, cables, and obvious
problems. If you do not find a problem, go to the "Quick Entry MAP" on
page 58 and follow the instructions for the new symptom.
Repeat this step with the second disk drive (if it was installed).
If the system has a diskette drive, go to "Step 1540-13" on page 113.
Go to "Step 1540-14" on page 114.
Advertisement
Table of Contents
