Test Your Connection To Hp Cloud - HP Jet Fusion 340 Product Documentation Site Preparation Manual

Each of the computers running HP SmartStream 3D Command Center Client should meet these requirements:
Local network access to the computer running HP SmartStream 3D Command Center Server
●
NOTE:
Intel Core processor with four virtual cores/threads
●
Computer running Windows 10 (64-bit) or Windows Server 2012 R2
●
8 GB RAM
●
400 GB available hard disk space
●
Local network
The local network(s) interconnecting the computers running HP SmartStream 3D Command Center and the
printers must meet the following requirements:
Ethernet (IPv4) connection, at least 100 MB/s
●
Build Manager
HP SmartStream 3D Build Manager is separate software that, unlike HP SmartStream 3D Command Center
(which helps you to monitor your printers), allows you to prepare and submit your jobs to the printer. The
computer that runs this software must have a direct network connection with the printer and with the computer
running HP SmartStream 3D Command Center Server, and must meet the following requirements:
Minimum: Intel Core i5, 16 GB RAM, 2 GB dedicated graphics card with DirectX 11 support
●
Recommended: Intel Core i7, 64 GB RAM, 4 GB dedicated graphics card with DirectX
●
IMPORTANT:
If you are planning to run non-HP software, make sure your computer complies with its requirements and that it
is installed before the agreed date of printer installation.

Test your connection to HP Cloud

You are responsible for testing your network before the day of installation to check your connection to the
HP Cloud from the computer running Command Center Server.
IMPORTANT:
Center – Installation and troubleshooting guide, which you can download from
SmartStream3DCommandCenter/manuals.
Process overview
1. Download HP SmartStream 3D Command Center Server to the designated computer that will be connected
to the HP Cloud 24/7.
2. Install HP SmartStream 3D Command Center Client in the same computer and in any other computer in the
same network on which you intend to use the software.
3. Sign in to your HP 3D Center by PrintOS account.
4. Add the Command Center Server app to your HP 3D Center by PrintOS account.
32 Chapter 5 Plan your computer and network environment
No connection to any printer is required.
Running Build Manager in a virtual environment is not supported.
If you have any doubts or problems during this procedure, see the HP SmartStream 3D Command
www.hp.com/go/
ENWW