Networking requirements
Only outgoing HTTPS ports (typically TCP 443) need to be opened in the perimeter firewall; no incoming
●
network ports need to be opened.
The Command Center Server computer needs to allow incoming traffic to the Command Center Server
●
application so that Command Center Clients can connect to the server.
To give Command Center Server access to the HP Cloud, you should check that your network is not blocking
●
the following endpoints:
www.printos.com, port 443 (or https://www.printos.com)
–
3dpconf.heleni.me, port 443 (or https://3dpconf.heleni.me)
–
*.amazonaws.com, port 443 (or https traffic to any host on the domain amazonaws.com)
–
h19002.www1.hp.com, port 21 (or ftp://h19002.www1.hp.com)
–
Connection to the Internet must be DSL or better.
●
To minimize disconnections:
●
Use hostnames or static IP addresses in devices and in the Command Center Server computer.
–
The computer in which Command Center Server is installed should always be on, awake, and
–
connected to the Internet.
If your network performs SSL/TLS inspection, you must configure the Command Center software to
●
support SSL bump with the certificate provided by your IT department.
If your proxy requires authentication, you must configure the Command Center proxy tab with the
●
information supplied by your IT department.
Computer requirements
Command Center Server computer
HP recommends having only one computer running HP SmartStream3D Command Center Server. It should meet
these requirements:
24/7 uptime (it never switches off or goes to sleep)
●
24/7 access to the HP Cloud
●
Local network access to all HP 3D devices
●
Intel Core processor with four virtual cores/threads
●
Computer running Windows 10 (64-bit) or Windows Server 2012 R2
●
8 GB RAM
●
400 GB available hard disk space
●
Command Center Client computers
Bear in mind that you can run this software in as many computers as required.
ENWW
Networking requirements
31