Service Switch Assembly - Maytag MLE22PD Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open the control panel (See page 4-3).
2. From inside the control panel, press the
locking tab and disconnect the wire harness
to the service switch from the control board.
Wire
Harness
3. Remove two #1 Phillips head screws
securing the switch to the bracket.
4. Remove the service switch wires from the
retainer clip and remove the switch with the
wire harness attached.

ServiCe SWiTCH aSSeMBlY

Service Switch
Assembly
Wire Retainer
Clip
Two #1 Phillips
Screws
5. To remove the service switch cam and
lock, remove the 11mm (7/16") nut and star
washer securing the cam to the lock shaft.
Remove the service switch cam from the
shaft.
6. Remove the retainer nut securing lock to
the control panel assembly. Remove lock
from the front of the control panel cover.
11mm Nut &
Star Washer
7. Remove the switch bracket assembly and
plastic bracket with hook that allows control
panel to be hooked in the service position.
Cam
Retainer Nut
Lock
Lock Nut
Plastic Bracket
TeCH Tip: When reassembling the service
switch assembly, place the metal switch
bracket against the control panel, and
then the plastic bracket on top of the metal
bracket.
4-7
Lock
Retainer Nut
Service Switch
Metal Bracket