Table of Contents
Advertisement
5
SERVICE & MAINTENANCE
Section
5.1 MAINTENANCE SCHEDULE
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
COMPONENT
All internal and external
nuts and bolts
Chipper anvil
Chipper blades
Shredder knives
Entire machine
PTO cross journals
PTO inner tubes
PTO shield retaining
bearing
Drive belt
Belt tension
Belt/pulley alignment
Grease zerks
(1) Perform more frequently under extremely dusty conditions.
(2) Perform more frequently when chipping dry or dirty wood.
As the Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine's
warranty. The aggressive, high-speed nature of chipping REQUIRES THE OWNER TO PERFORM THE
ABOVE LISTED NORMAL MAINTENANCE. Special consideration to maintain and re-torque the CHIPPER
ANVIL, CHIPPER BLADES, and ALL INTERNAL AND EXTERNAL NUTS AND BOLTS is the sole responsibility
of the Owner. Failure by the Owner to do so shall be cause for denial of warranty.
SERVICE AND MAINTENANCE SCHEDULE
MAINTENANCE REQUIRED
Check tightness
Check clearance and re-torque to
75 ft-lbs. (1)
Check sharpness and re-torque to
25 ft-lbs. (2)
Check condition
Clean
Lube
Lube
Lube
Check
Check
Check
Lube
5 INCH CHIPPER/SHREDDER/BLOWER
WARNING
To prevent personal injury or property damage: shut
off engine and make sure that all moving parts have
come to a complete stop before, servicing, adjusting or
repairing. Disconnect the battery and remove ignition
key where applicable.
FREQUENCY
BEFORE
EVERY 8
EACH
HOURS
USE
●
●
●
●
●
●
●
●
EVERY
EVERY
25
50
HOURS
HOURS
●
●
●
●
13
Advertisement
Table of Contents
