Operation Safety - Echo Bear Cat SC5540B Owner's Manual

SAFETY
11. Always use an approved fuel container. Do not
remove gas cap or add fuel when engine is running.
Add fuel to a cool engine only.
12. Do not fill fuel tank indoors. Keep open flames, sparks,
smoking materials and other sources of combustion
away from fuel.
13. Do not operate machine without shields in place.
Failure to do so may cause serious injury or death.
14. Keep all guards, deflectors, and shields in good
working condition.
15. Before inspecting or servicing any part of this machine,
shut off the machine and make sure all moving parts
have come to a complete stop. Disconnect the battery
and remove the ignition key where applicable.
16. Check that all screws, nuts, bolts, and other fasteners
are secured, tightened and in proper working condition
before starting the machine.
17. Do not transport or move machine while it is operating
or running.

1.3 OPERATION SAFETY

1. Always stand clear of discharge area when operating
this machine. Keep face and body away from feed
and discharge openings.
2. Keep hands and feet out of feed and discharge
openings while machine is operating to avoid serious
personal injury. Stop and allow
machine to come to a complete
stop before clearing obstructions.
3. Set up your work site so you are
not endangering traffic and the
public. Take great care to provide
adequate warnings.
4. Do not climb on machine when operating. Keep
proper balance and footing at all times.
2
5. Check cutting chamber to verify it is empty before
6. The rotor will continue to rotate after being disengaged.
7. Do not insert branches with a diameter larger than
8. When feeding material into machine, do not allow
9. Ensure debris does not blow into traffic, parked cars,
10. Keep the machine clear of debris and other
11. Do not allow processed material to build up in the
12. If the machine becomes clogged, the cutting
13. On electric start models, disconnect cables from
14. Check blade bolts for proper torque after every 8 hours
5 INCH CHIPPER/SHREDDER/BLOWER
starting the machine.
Shut off the machine and make sure all moving parts
have come to a complete stop before inspecting or
servicing any part of the machine. Disconnect the
battery and remove the ignition key if applicable.
the max chipper capacity into machine or machine
damage may occur.
metal, rocks, bottles, cans or any other foreign
material to be fed into the machine.
or pedestrians.
accumulations.
discharge area. This may prevent proper discharge
and can result in kickback of material through the
feed opening.
mechanism strikes any foreign object, or the machine
starts vibrating or making an unusual noise, shut off
machine immediately and make sure all moving parts
have come to a complete stop. Disconnect the battery
and remove the ignition key if applicable. After the
machine stops: A) Inspect for damage, B) Replace
or repair any damaged parts, and C) Check for and
tighten any loose parts.
battery before doing any inspection or service.
Remove key.
of operation. Check blades and rotate or resharpen
daily or as required to keep blades sharp. Failure
to do so may cause poor performance, damage or
personal injury and will void the machine warranty.