Sony CLIE PEG-TJ27 Frequently Asked Questions Manual page 27

I cannot perform a IR HotSync
B If you are using Windows Me, click
(Notification area) at the bottom right of your computer window and click
[Local] in the Setup window. Then ensure [Serial Port] of the simulated
port for IR communication is selected.
B Ensure [Local] and [IR to a PC/handheld] are selected in the HotSync
screen on your CLIÉ handheld.
B Point the IR port of your CLIÉ handheld directly at the IR port of your
computer. The distance between the IR ports of your CLIÉ handheld and
computer should be 4 to 8 inches (approximately 10 to 20 centimeters). The
optimum distance for beaming may vary depending on devices.
B You cannot perform the IR HotSync
power is inadequate. After charging the battery of your CLIÉ handheld, try
®
the IR HotSync
B Reduce the transmission speed.
Tap [IR to a PC/Handheld] in the Preferences screen for [Connection].
Then tap [Edit...], [Details...] and specify [Speed:] in the Details screen.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I cannot beam data
Verify the following first
B Select [General] in the Preferences screen and check that [Beam
Receive:] is set to [On].
B Make sure you point the IR port of your CLIÉ handheld directly at the IR
port of the target device.
B Make sure the distance between your CLIÉ handheld and the target device
is 4 to 8 inches (approximately 10 to 20 centimeters). The optimum distance
for beaming may vary depending on devices.
B Sometimes file contents may be accidentally linked to the name of another
file when you transfer many files at the same time using the IR port. Transfer
files one by one when using the IR port.
®
operation (continued)
®
operation again.
(HotSync) in the task tray
operation if the remaining battery
27