Table of Contents
Advertisement
Load Default Setting
Clicking the Load button will make the switch being set to the original
configuration.
※ Note: It exclude to change user name, password and IP configuration. If
you want to restore default setting including IP and user name password,
then you can press the reset button for hardware base reset.
More detail information about Load Default Setting - Hardware Base is
described as following.
The purpose of this function is to provide a method for the network
administrator to restore all configurations to the default value.
(1) To activate this function, the user should follow the following procedures.
Press the "Load default" button for 3 seconds until you see the LED blinking.
(2) When LED starts blinking, it means the CPU is executing the "load default"
procedure. You can release the button now.
After completing this procedure, all the factory default value will be restored. It
includes the IP address, the user name, the password and all switch
configurations.
Figure 1-6
10
Advertisement
Table of Contents
