Turning On Battery Save Mode; Acquiring Gps Signals; Radio; Transmitting - Garmin Rino 750t Owner's Manual

Turning On Battery Save Mode

You can use battery save mode to prolong the battery life.
From the app drawer, select Setup > Display > Battery Save > On.
In battery save mode, the screen shuts off when the backlight times out. You can select
screen.

Acquiring GPS Signals

When you turn on your navigation device, the GPS receiver must collect satellite data and establish the current
location. The time required to acquire satellite signals varies based on several factors, including how far you are
from the location where you last used your navigation device, whether you have a clear view of the sky, and how
long it has been since you last used your navigation device. The first time you turn on your navigation device, it
may take several minutes to acquire satellite signals.
1 Turn on the device.
2 Wait while the device locates satellites.
3 If necessary, go to an open area, away from tall buildings and trees.
in the status bar indicates the satellite signal strength. When at least half the bars are filled, the device is
ready for navigation.
In the United States, this device uses General Mobile Radio Service (GMRS) for two-way communication with
other compatible radio devices.
In Canada, this device uses Family Radio Service (FRS) and General Mobile Radio Service (GMRS) for two-way
communication with other compatible radio devices.
In Australia, this device uses UHF Citizen Band Radio Service (UHF CBRS), and in New Zealand, this device uses
UHF Personal Radio Service (PRS) for two-way communication with other compatible radio devices.
When communicating with other Rino radio devices, additional features are available.

Transmitting

To communicate with other Rino users or compatible radio devices, you must be on the same channel and code
(Channels and Codes, page 8).
1 Hold PTT.
2 Speak into the front of the device.
3 After you are finished speaking, release PTT.
The radio transmits your position information. You cannot hear incoming transmissions until your
transmission is complete. A roger tone sounds on your radio and on the radios receiving your transmission
to confirm that the transmission is complete.
NOTE: You can change or disable the roger tone

The Radio App

Using the radio app, you can view information about the radio, control the radio channel and squelch codes, and
customize the radio features.
Icons along the top of the radio page provide useful information about the radio.
: Indicates the activity status of the radio. When an arrow is pointing at the radio, the radio is receiving a
transmission. When an arrow is pointing away from the radio, the radio is transmitting.
: The radio is ready to transmit position information
: Weather alerts are enabled
: The radio is muted (Adjusting the Radio Volume,

Radio

Radio
(Setting the Device Tones,
(Peer-to-Peer Positioning,
(Radio App Settings, page 12).
page 8).
to turn on the
page 34).
page 10).
7