Table of Contents
Advertisement
Step 4.
Remove the hard disk drives and filler panels from the hard disk drive bays.
Step 5.
Remove the screws from the bezel.
Video connector
screws
Figure 75. Screws removal
Step 6.
Remove the screws from the video connector.
Step 7.
Pull the top of the bezel out slightly; then, rotate it downward until the tabs on the bottom of the
bezel disengages from the chassis and set it aside.
Step 8.
Slide the hot-swap hard disk drive cage forward into the server until the screw holes on the drive
cage align with the screw holes on the chassis.
Bezel
Figure 76. Hard disk drive cage installation
Step 9.
Insert the tabs on the bottom of the bezel into the holes on the chassis.
Step 10. Reinstall the bezel screws and the video connector screws.
Step 11. Align the sides of the hard disk drive backplane with the slots on the backplane bracket.
Step 12. Insert the hard disk drive backplane into the slots on the backplane bracket and push the hard disk
drive backplane down until the backplane is fully seated.
Bezel screws
Hard disk drive cage
.
Chapter 2
Installing optional devices
93
Advertisement
Table of Contents
