Table of Contents
Advertisement
User Manual
/
CBA850
FIRST TIME SETUP
Administrator Password and Time Zone
Enter a password for the administrator who will have full access to
the router's management interface.
You can use the default password on the back of your product, or
you can create a custom Administrator Password.
Configuring Your APN and Modem Authentication
If you are using a SIM-based modem (LTE/GSM/HSPA) with your
Cradlepoint router you may need to configure the APN before it
will properly connect to your carrier. Wireless carriers offer several
APNs so check with your carrier to confirm the appropriate one to
use. You can use the default password on the back of your product,
or you can create a custom Administrator Password.
NOTE: DO NOT USE THIS APN WIZARD if you have already configured
an APN. Any specific modem settings will not be overwritten by
this generic APN setup. Leave this setting as default and after
finishing this Wizard go to the CONNECTION MANAGER page, select
your modem, and edit the settings. The SIM PIN/APN tab has more
available settings than are provided here.
Some modems require a username and password to be entered to
authenticate with a carrier. Do not fill in the following fields unless
you are sure your modem needs authentication.
•
Authentication Protocol
•
Username
•
Password
Enable and Configure Failure Check
Failure check will test the connection to verify the WAN device is
connected.
•
Idle Check Interval: Set the number of seconds the router will
wait between checks to see if the WAN is still available.
SETUP WIZARDS
ECM REGISTRATION
To register the router
with Cradlepoint ECM
you must first have an
account. If you need to
create an account you can
signup at
cradlepoint.
com.
Once you've created an
account, or if you already
have one, you can enter your ECM username and password to register
the router.
©2016 Cradlepoint. All Rights Reserved.
|
+1.855.813.3385
|
cradlepoint.com
8/25/16
55
Advertisement
Table of Contents
