Partially Reflective Glass Replacement; On/Off Switch Replacement - Dimplex DF2690 Service Manual

from the flicker motor and lifting out.
8. Remove light filter bracket (the metal bracket will have
a tinted film adhered to it) for easier access to light
bulbs.
9. Replace light bulbs.
10. Replace light filter bracket and flicker rod.
11. Replace the log set by inserting the front edge of the
fireplace and push down on the rear edge of the ember
bed until it snaps into place.
12. Lay unit on it's back and slide front glass back into
position and attach trim.
pARTIALLy REFLECTIvE gLASS
REpLACEMENT
Tools Required: Phillips head Screwdriver
Flat Head Screwdriver
WARNINg: If unit was operating prior to servicing allow
at least 10 minutes for light bulbs and heating element
to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
1. Slide fireplace out of mantel.
2. Lay unit on it's back for safe removal of front glass.
3. Remove three (3) Phillips screws from the right side of
trim.
4. Slide glass to right side of fireplace to remove. (Figure
5)
CAUTION: Even though the glass is safety glass it
may break if bumped, struck of dropped. Care must be
taken when handling the glass.
5. Pull the front edge of the plastic ember bed or plastic
grate up and forward until the rear tab releases from
the ledge located at the bottom of the partially reflective
glass.
!
IMpORTANT: Only handle the log-set by the plastic
ember-bed, not the logs themselves.
!
NOTE: Log-set fits tightly into firebox. Some force
Figure 7
Retaining
Clip
8
may be necessary to remove.
6. Loosen but do not remove the two (2) Philips screws on
the retaining clips that hold the partially reflective glass
in place, and swivel down so that the retaining clips
clear the edge of the partially reflective glass. (Figure 7)
7. Push the partially reflective glass up from underneath
to clear the frame and remove.
8. Insert replacement partially reflective glass top end first
and lay the bottom end gently in the bottom track of the
frame.
9. Tighten clips back into place and reassemble fireplace
in reverse order as described above.

ON/OFF SWITCh REpLACEMENT

Tools Required: Phillips head Screwdriver
WARNINg: If unit was operating prior to servicing allow
at least 10 minutes for light bulbs and heating element
to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
1. Remove the firebox from the mantel.
2. Lay unit on its back.
3. Remove the 12 screws that fasten the bottom cover to
the rest of the firebox. There are: two (2) screws on
each side; two (2) screws on the back panel (you may
have to tip the bottom of the fireplace up if it is laying
on its back), four (4) screws in the front directly under
Figure 8
Figure 9
Partially
Reflective
Glass
Retainer Clips
(one top, one bottom)
Flat Head Screwdriver
Screws To Remove
ON/OFF
Switch
www.dimplex.com