To Perform A Test Run; To Perform A Test Run Using The Wireless Remote Control - Daikin FTXA20C2V1BW Installer's Reference Manual

11 | Commissioning

11.3 To perform a test run

11.3.1 To perform a test run using the wireless remote control

Installer reference guide
50
There are NO loose connections or damaged electrical components in the switch box.
The insulation resistance of the compressor is OK.
There are NO damaged components or squeezed pipes on the inside of the indoor and
outdoor units.
There are NO refrigerant leaks.
The correct pipe size is installed and the pipes are properly insulated.
The stop valves (gas and liquid) on the outdoor unit are fully open.
Prerequisite: Power supply MUST be in the specified range.
Prerequisite: Test run may be performed in cooling or heating mode.
Prerequisite: Test run should be performed in accordance with the operation
manual of the indoor unit to make sure that all functions and parts are working
properly.
1 In cooling mode, select the lowest programmable temperature. In heating
mode, select the highest programmable temperature. Test run can be
disabled if necessary.
2 When the test run is finished, set the temperature to a normal level. In cooling
mode: 26~28°C, in heating mode: 20~24°C.
3 The system stops operating 3 minutes after the unit is turned OFF.
1 Press to switch the system on.
2 Press and
3 Press , select and press
Result: Test run operation will stop automatically after about 30 minutes.
4 To stop operation sooner, press
simultaneously.
.
.
CTXA-C(W)(B)(S) + FTXA-C(W)(B)(S)
Daikin room air conditioner
4P518023-15P – 2023.05