Grandstream Networks GSC3516 User Manual page 42

Do Not Escape '#' as %23 in SIP URI
Record Mode
Environment
Ringtone
Auto Config CPT by Region
● Ring Back Tone
● Busy Tone
● Reorder Tone
● Call-Waiting Tone
Call-Waiting Tone Gain
Default Ring Cadence
Multicast/Group Paging
Paging Barge
filtered and dial 057188008888 directly
Replaces # by %23 for some special situations.
Configures phone recording mode
● If set to "Record locally", then will use the local tape recorder for call recording, and the
audio file will be saved in accordance with the tape recorder setup
● If set to "Record on PortaOne", then will send the specified SIP messages to the
corresponding server;
● If set to "Record on UCM", then will send the recording feature code to the UCM server to
request for recording, and the recording function will be executed by the server.
Sets operating environment for the device.
● When set to "Small and medium size room & used on desk", the sound pickup range is
increased and ENC is reduced
● When set to "Large room & used on empty area", the sound pickup range is reduced and
ENC is increased.
The default value is "Large room & used on empty area".
Phone Settings – Call Settings
Configures whether to choose Call Progress Tone automatically by region. If set to "Yes", the device
will configure CPT (Call Progress Tone) according to different regions automatically. If set to "No",
you can manual configure CPT parameters. The default setting is "No".
Configures tone frequencies according to user preference. By default, the tones are set to North
American frequencies. Frequencies should be configured with known values to avoid uncomfortable
high pitch sounds.
● Syntax: f1=val,f2=val [,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in "ms") while OFF is the period of silence. In order to set a
continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then
repeats the pattern.
Please refer to the document below to determine your local call progress tones: http://www.itu.int/ITU-
T/inr/forms/files/tones-0203.pdf
Adjusts the call waiting tone volume. Users can select "Low", "Medium" or "High". The default setting
is "Low".
Defines the ring cadence for the device. The default setting is: c=2000/4000.
Phone Settings – Ringtone
Multicast Paging
Sets the threshold of paging calls. If the paging call's priority is higher than the threshold, the
existing call will be hold and the paging call will be answered. Otherwise, the existing call does not
be affected. If it is set to Disable (Default), any paging call will not be answered.