Grandstream Networks GSC3516 User Manual page 10

Powering and Connecting GSC3516
The GSC3516 can be powered on using PoE/PoE+ switch or PoE injector using the following steps:
Step 1: Plug an RJ45 Ethernet cable into the network port of the GSC3516.
Step 2: Plug the other end into the power over Ethernet (PoE) switch or PoE injector.
Connecting Wiring Seat for GSC3516
GSC3516 support to connect a "Key & LED" or "Normal Key" to the 2-pin port via Wiring Seat using the following steps:
Step 1: Take the wiring seat from the install kits.
Step 2: Connect the "Key & LED" or "Normal Key" with the wiring seat (as shown in the figure below)
Note: This port supports the parallel connection of an incandescent lamp (with less than 1W) or an LED lamp (with less than
100mA).
Powering and Connecting GSC3506
GSC3506 can be powered on using PoE/PoE+ switch or PoE injector using the following steps:
Step 1: Plug an RJ45 Ethernet cable into the network port of the GSC3506.
Step 2: Plug the other end into the power over Ethernet (PoE) switch or PoE injector.
Note
Powering GSC3516
Connecting Wiring Seat