Installing Memory - Dell Optiflex 740 User Manual

Installing Memory
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE: Memory purchased from Dell is covered under your computer warranty.
1. Follow the procedures in Before You
2. If you are using:
a desktop computer: remove the optical drive (see
l
a small form factor computer: first remove the optical drive (see
l
reader (see Removing a Floppy Drive or Media Card
3. Press out the securing clip at each end of the memory module connector.
1 memory connector closest to processor
4. Align the notch on the bottom of the module with the crossbar in the connector.
1 cutouts (2) 2
4 crossbar
NOTICE: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the
module.
5. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
Begin.
Removing an Optical
Reader).
2 connector 3
memory module
Drive).
Removing an Optical Drive) and then remove the floppy drive or media card
securing clips (2)
3 notch