Table of Contents
Advertisement
CAUTION:
Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
NOTE:
See the documentation that came with the card for information on configuring the card, making internal connections, or customizing it for your
computer.
6. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
1
fully seated card
4
bracket caught outside of slot
7. Before closing the card retention latch, ensure that:
The tops of all cards and filler brackets are flush with the alignment guide
l
The notch in the top of the card or filler bracket fits around the alignment guide
l
8. Secure the card(s) by closing the card retention latch and snapping it into place.
NOTICE:
Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage
to the equipment.
9. Connect any cables that should be attached to the card.
10. Replace the computer cover (see
NOTE:
See the documentation for the card for information about the card's cable connections.
11. If you installed a sound card:
a. Enter system setup, select Integrated Audio from the Onboard Devices group, and change the setting to Off (see
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the line-in connector on the back panel
of the computer (see
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
12. If you installed a network adapter card and want to turn off the integrated network adapter:
a. Enter system setup, select Integrated NIC from the Onboard Devices group, and change the setting to Off (see
b. Connect the network cable to the network adapter card's connectors. Do not connect the network cable to the integrated network connector on
the back panel of the computer.
13. Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1. Follow the procedures in
Before You
NOTE:
For PCI card locations, see
2 not fully seated card
Replacing the Computer
Cover).
Back-Panel
Connectors).
Begin.
System Board
Components.
3
bracket within slot
System
Setup).
System
Setup).
Advertisement
Table of Contents
Troubleshooting
