Table of Contents
Advertisement
Back to Contents Page
PCI, PCI Express Cards, and PS/2 Serial Port Adapters
PCI, PCI Express Cards, and PS/2 Serial Port Adapters
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
Your Dell™ computer supports a PS/2 serial port adapter and provides the following connectors for PCI and PCI Express cards:
One low-profile PCI card slot
l
One low-profile PCI Express x16 card slot
l
NOTE:
Your Dell computer uses only PCI and PCI Express slots. ISA cards are not supported.
PCI Cards
Installing a PCI Card
1. Follow the procedures in
Before You
NOTE:
For PCI card locations, see
2. Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
1
release tab
4
card-edge connector
3. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with
4. If you are replacing a card that is already installed in the computer, remove the card. If necessary, disconnect any cables connected to the card. Then
continue with step 6.
5. Prepare the card for installation.
Begin.
System Board
Components.
2
card retention latch
5
card connector
3
card
step
5.
Advertisement
Table of Contents
Troubleshooting
