Follett Horizon HCD1000R Series Installation Instructions Manual page 4

2.1 2.2
Condenser installation specifi cations
S-trap
required
➊
P-trap
required
MODEL CORPORATION SERIAL NO Easton Pennsylvania PART NO
FULL LOAD AMPS VOLTS HZ PHASE SINGLE
MOTOR COMPRESSOR THERMALLY PROTECTED
REFRIGERANT CHARGE OZ
208264 DESIGN PRESSURE HIGH SIDE LOW SIDE PSIG
Module No. Stock Module Identification Plate MIN. BRANCH CIRCUIT AMPACITY AMPS UL R R UL NSF MADE IN THE USA
Product MAX. BRANCH CIRCUIT FUSE SIZE AMPS C
Service No.
EVAPORATOR
UNIT
Site layout:
• Outdoor ambient temperature range: –20 F to 120 F (–29 C to 49 C)
• Installation with condenser unit elevations above 20' (6,1m) require an S-trap at the midpoint
➊
of the rise
• Maximum line rise must not exceed 35' (10,7m)
• Maximum line set length must not exceed 100' (30,5m)
• Maximum line drop must not exceed 15' (4,6m)
Note: The service loop is not included when calculating the length, rise or drop
of the tubing run.
Note: 1400/1650 units only:
HCD1400/1650 condensing units contain a liquid to suction line heat exchanger. To maintain
optimum liquid refrigerant sub-cooling from the heat exchanger, the entire liquid line should
be insulated separately from the suction line.
4
➍
100' max.
(30,5m)
EVAPORATOR UNIT LEVEL
➌
100' max.
(30,5m)
CONDENSER UNIT
maximum
line rise
CONDENSER UNIT
CONDENSER UNIT
maximum
line drop
➋
➌
➍
REMOTE CONDENSING UNIT
➋
+35'
(+10,7m)
+20'
(+6,1m)
+3'
(+0,9m)
–15'
(–4,6m)
➍