Operation; Shoulder Strap Attachment; Know Your Blower; Stop Switch - Craftsman 358.794760 Operator's Manual

SHOULDER STRAP ATTACHMENT
(optional accessory #71-85783)
1. Pass the shoulder strap over your
head and onto your left shoulder.
2. Snap the hook onto the retainer
(see following illustration).
BLOWER USE I VACUUM USE
Retainer __ II J_S_: ._,'_
KNOW YOUR BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Throttle Position Lever Elbow Tube
STOP Switch
Throttle Trigger
Upper Vacuum Tube
Starter
R°P X
Fuel Mix
Fill Cap
Spark Plug
Upper Blower Tube
Lower Vacuum Tube
Lower Blower Tube High-
Speed
Nozzle
Primer
Bulb
STOP SWITCH
The STOP switch is used to stop the
engine. To stop the engine, push and
hold the STOP switch in the STOP posi-
tion until the engine stops.
THROTTLE TRIGGER
The THROq-i-LE TRIGGER is used to se-
lect the desired engine speed.
THROTTLE POSITION LEVER
The THRO]q-LE POSITION LEVER is de-
signed to allow setting engine speed
during blower use only. To avoid caus-
ing damage to the unit, DO NOT at-
tempt to use the throttle position lever
during vacuum use.
Vacuum Handle
PRIMER BULB
The PRIMER BULB removes air from the
carburetor and fuel lines and fills them
with fuel. This allows you to start the en-
gine with fewer pulls on the starter rope.
Activate primer bulb by pressing it and
allowing it to return to its original posi-
tion.
START LEVER
The START LEVER helps to supply fuel to
the engine to aid in starting. Activate the
starting system by moving the start lever
to the START position. DO NOT squeeze
the throttle trigger until the engine has
started and runs. After the engine starts,
allow the engine to warm- up 10-15
seconds, then fully squeeze the throttle
trigger to deactivate the starting system
(start lever returns to RUN position).
-8-