Writing Timer And Counter Set Values - Omron ZEN-8E Communications Manual

SECTION 2 CompoWay/F Communications Protocol

■ Writing Timer and Counter Set Values

● Reading and Writing Timer Set Values
Example 1:
Example 2:
Example 3:
Example 4:
22
Error Occurred
Response
Error name
code
1002 Command too short
1101 Area type error
1003 Number of elements/
data mismatch
1100 Parameter error
3003 Read-only error
2203 Operation error
Note: With the Write Variable Area service,
do not occur. If there is sufficient data for the number of elements
in the service request PDU, the error is processed as a
of elements/data mismatch" error.
Timer set values (SVs) can be read and written. The rightmost and
leftmost four bytes contain the ON time and OFF time for twin timers
and the rightmost four bytes contain the ON time for other timers.
Writing the SV of Timers Other Than Twin Timers
Command
[STX]000000102C100000000010000270F
Reading the SV of Timers Other Than Twin Timers
Command
[STX]000000101C10000000001
Response
[STX]00000010100000000270F
Writing the SV of Twin Timers
Command
[STX]000000102C100000000010064 270F
Writing the SV of Twin Timers
Command
[STX]000000101C10000000001
Cause
The command is too short.
The variable type is wrong.
The number of data does not
match the number of elements.
• Bit position is not 00.
• The write data is out of the set-
ting range.
• The bit number is out of range.
Variable type "C0" was written to.
Unit error (Memory error
occurred, or unused command
was sent.)
command too long" errors
"
number
"
ON time: 9999 (H'270F)
ON time: 9999 (H'270F)
OFF time: 9999 (H'270F)
ON time: 100 (H'64)