Assigning The Ip Address To The Camera; Connecting The Camera To A Computer - Sony IPELA SNC-RZ30N Install Manual

Assigning the IP
Address to the
Camera
To connect the camera to a network, you
need to assign a new IP address to the
camera.
Before assigning the IP address, connect the
camera to a computer or a network. To
connect to the computer, use a commercially
available Ethernet cable (cross cable). To
connect to the network, use a commercially
available Ethernet cable (straight cable).
You can assign the IP address in two ways:
• Using the setup program stored in
the supplied CD-ROM
For details on the operations, see
"Assigning the IP Address Using the Setup
Program" on page 13.
• Using the ARP (Address Resolution
Protocol) commands
Open the DOS window on the computer and
enter the specified ARP commands.
For details on the operations, see

"Assigning the IP Address to the Camera

Using ARP Commands" in the User's Guide
stored in the supplied CD-ROM.
Note
For determining the IP address to be
assigned to the camera, consult your system
administrator.
12
GB
Assigning the IP Address to the Camera
Connecting the Camera to a
Computer
SNC-RZ30N/RZ30P (rear)
18 16 14 12 10 8 6 4 2
17 15 13 11 9 7 5 3 1
!
DC IN 12V
DC IN
12 V
Ethernet
cable (cross,
not supplied)
Network
connector
Computer
1
Using a commercially available
Ethernet cable (cross), connect
the (Ethernet) port of the
camera to the network
connector of a computer.
2
Connect the power cord to the
AC power adaptor (both
supplied), and connect the DC
IN 12 V connector of the camera
to an AC outlet.
AC power adaptor
(supplied)
Power cord
(supplied)
to an AC
outlet