Mitsubishi Electric PLA-A EA Series Operation Manual page 10

3. Operation
<Vane setting>
Fri
Off
Vane Vent.
F1 F2 F3 F4
RETURN SELECT
MENU
HOLD
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
<Vent. setting>
Fri
Low
Vent.
F1 F2 F3 F4
RETURN SELECT
MENU
HOLD
<Returning to the Main menu>
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu: RETURN
Cursor
F1 F2 F3 F4
RETURN SELECT
MENU
HOLD
en
9
Press the [F1] or [F2] button.
Press the button as indicated above
to go through the following setting
options.
Auto
Auto Step 1
Step 3 Step 4
ON
Swing
OFF
Swing
Select "Swing" to move the vanes
up and down automatically.
When set to "Step 1" through
"Step 5", the vane will be fixed at
the selected angle.
• under the vane setting icon
This icon will appear when the vane
is set to "Step 5" and the fan oper-
ates at low speed during cooling or
drying operation (depends on the
model).
The icon will go off in an hour, and
the vane setting will automatically
change.
Press the [F4] button to go through
the ventilation setting options in the
order of "Off ", "Low ", and "High".
* Settable only when LOSSNAY unit
is connected.
Off Low
Off Low
• The fan on some models of indoor
ON
units may be interlocked with cer-
OFF
tain models of ventilation units.
Press the [RETURN] button to go
back to the Main menu.
ON
OFF
Notes:
During swing operation, the directional indication on the screen
●
does not change in sync with the directional vanes on the unit.
Available directions depend on the type of unit connected.
●
In the following cases, the actual air direction will differ from the
●
direction indicated on the remote controller display.
1. While the display is in "STAND BY" or "DEFROST" states.
2. I mmediately after starting heat mode (while the system is wait-
ing for the mode change to take effect).
Step 2
3. I n heat mode, when room temperature is higher than the tem-
perature setting.
Step 5
<How to set the fixed up/down air direction>
Note:
This function cannot be set depending on the outdoor unit to be
●
connected.
• For PLA-A▪EA8, only the particular outlet can be fixed to certain
direction with the procedures below. Once fixed, only the set outlet is
fixed every time air conditioner is turned on. (Other outlets follow UP/
DOWN air direction setting of remote controller.)
■
Explanation of word
• "Refrigerant address No." and "Unit No." are the numbers given to
each air conditioner.
• "Outlet No." is the number given to each outlet of air conditioner.
(Refer to the illustration below.)
• "Up/Down air direction" is the direction (angle) to fix.
Remote controller setting
The airflow direction of this outlet
is controlled by the airflow direc-
tion setting of remote controller.
High
High
Outlet No. 2
Outlet No. 1
Note:
The outlet No. is indicated by the number of grooves on both
ends of each air outlet. Set the air direction while checking the
information shown on the remote controller display.
Horizontal airflow
Fixed
The airflow direction of this outlet is fixed
in particular direction.
* When it is cold because of direct
airflow, the airflow direction can be
fixed horizontally to avoid direct airflow.
Outlet No. 3
Outlet No. 4
Air outlet identification marks