Erps - Planet GS-4210-24T4SR User Manual

4.6.2 ERPS

This page allows the user to inspect and configure the current ERPS Instance; screen in
Object
• Enable
• ERPS ID
• Version
• Ring Type
• Port 0
• Port 1
• Node ID
• Control Vlan
• Revertive
• Guard Time
• WTR Time
• Holdoff Time
Figure 4-6-2: Ethernet Ring Protocol Switch page screenshot
Description
Enables ERPS on the switch. ERPS must be enabled globally on the switch
before it can enable on an ERPS ring.
Major ring group ID for the interconnected sub-ring. It is used to send topology
change updates on major ring. If ring is major, this value is same as the
protection group ID of this ring.
ERPS Protocol Version - v1 or v2
Type of Protecting ring.
This will create a Port 0 of the switch in the ring.
This will create "Port 1" of the switch in the Ring. As interconnected sub-ring will
have only one ring port, "Port 1" is configured as "0" for interconnected sub-ring.
"0" in this field indicates that no "Port 1" is associated with this instance
A MAC address unique to the ring node. The MAC address must be specified in
the format xx:xx:xx:xx:xx:xx
VLAN configuration of the Protection Group.
ERPS Protocol Version - v1 or v2
Guard timeout value to be used to prevent ring nodes from receiving outdated
R-APS messages.
The period of the guard timer can be configured in 10 ms steps between 10 ms
and 2 seconds, with a default value of 500 ms
Remaining WTR timeout in milliseconds.
The timing value to be used to make persistent check on Signal Fail before
switching.
The range of the hold off timer is 0 to 10 seconds in steps of 100 ms
User's Manual of GS-4210 Series
344
Figure 4-6-2 and Figure 4-6-3 appears.