Yamaha ACC-GNRST-30-20, EF3000iSE, EF3000iSEB - Remote Key Fob Manual

INTRODUCTION

This QuickStart Remote Key Fob is designed to be used as a replacement or additional remote control only for the QuickStart Remote Start Kit (part number ACC-GNRST-30-00) installed on an EF3000iSE/EF3000iSEB generator. Follow the instructions provided with the QuickStart Remote Start Kit for proper use of this key fob.

Please read and understand these instructions completely before installation to avoid possible injury to yourself, or damage to the accessory or generator.

• This installation should be performed by an authorized Yamaha dealer or a qualified mechanic.
• The QuickStart Remote Start Kit has been tested and approved by the FCC and RSS, and is intended for sale in the United States and Canada ONLY.

DEALER

These instructions contain important information for future reference and must be given to the customer.

PARTS LIST

This kit contains the following component. Before beginning installation confirm there are no missing or damaged components.

PREPARATION

Make certain that generator is cool before programming the remote start kit circuit board for the new key fob. Generator components can be extremely hot and cause serious burns to skin.

• Place generator on a secure flat surface.
• Clean the generator before beginning installation.
• Remove the screw on the rear access cover and slide the cover off generator. (Fig. 1)
  

INSTALLATION

Programming a key fob code:

NOTE: Each key fob has a unique code. The generator can be programmed to receive signals from several different key fobs.

• Use a paper clip or similar object to press the "ADD" button on the backside of key fob case. (Fig. 2)
  
• Once the "ADD" button is pressed, a blue LED light ("MODE_IND") will be visible flashing next to the ADD button.
• Press the "START" button and then the "STOP" button while the LED is flashing.
• Wait for blue LED light to stop flashing, indicating that a code has been selected and programmed by the key fob.

Programming the receiver to learn the new code:

• On the receiver circuit board inside the genera tor, locate and press the small white button labeled "LEARN". (Fig. 3)
  
• A green LED will flash indicating that the receiver is now in "LEARN" mode.

NOTE: To erase all old codes, such as when the original key fob has been lost, press and hold the "LEARN" button until the green light goes out (approximately 10 seconds). Then press the button again as described above to put the receiver in "LEARN" mode.

• With the green LED flashing, press the "START" button on the key fob to program the receiver to recognize the new "START" code.
• Press the "STOP" button to program the receiver to recognize the new "STOP" code.
• After 20 seconds, the green LED will turn off, indicating that the receiver is out of "LEARN" mode. Alternatively, the "LEARN" switch can be pressed again to exit learn mode.

Confirm proper operation:

• Press the "START" button to confirm that the generator starts. Then press the "STOP" button to confirm that the generator stops again.
• If the key fob transmission causes interference with another device, repeat the above procedure to program and receive another code.

CUSTOMER SERVICE:

For further information see your Yamaha dealer.

Battery replacement:
See your Yamaha dealer for battery replacement.

• Improperly replacing the battery can permanently damage the remote key fob's circuit board.
• Refer to local hazardous waste regulations when disposing of transmitter batteries.