Terminal Panel Features - NEC NP-PH1000U User Manual

Terminal Panel Features

13 11
1. COMPUTER 1 IN/ Component Input Connector (Mini D-Sub 15 Pin) (→ page 13, 160, 165)
2. COMPUTER 2 IN / Component Input Connector (Mini D-Sub 15 Pin) (→ page 160, 165)
3. COMPUTER 3 IN/Component (R/Cr, G/Y, B/Cb, H, V) Connectors (BNC × 5) (→ page 160, 165)
4. HDMI IN Connector (Type A) (→ page 161, 162, 166)
5. DisplayPort IN Connector (DisplayPort 20P)(→ page 161)
6. MONITOR OUT (COMP 1) Connector (Mini D-Sub 15 Pin) (→ page 163)
7. VIDEO IN Connector (BNC) (→ page 164)
8. S-VIDEO IN Connector (Mini DIN 4 Pin) (→ page 164)
9. LAN Port (RJ-45) (→ page 167)
10. USB Port (Type A) (→ page 73)
11. PC CONTROL Port (D-Sub 9 Pin) (→ page 227)
Use this port to connect a PC or control system. This enables you to control the projector using serial communica-
tion protocol. If you are writing your own program, typical PC control codes are on page 227.
12. REMOTE Connector (Stereo Mini)
Use this connector for wired remote control of the projector using the NEC optional remote control.
Connect the projector and optional remote control using a commercially available wired remote control cable.
NOTE:
• Connecting the remote cable to the REMOTE mini jack on the terminal panel will make the wireless operation unavailable.
13. USB (LAN) Port
14. Optional Slot (SLOT) (→ page 213)
9 4
12
(for optional Wireless LAN Unit) (→ page 168)
5 10 2
7
1. Introduction
3 1 7
14 6
8