Hardware Installation; Central Processing Unit (Cpu); Fan Headers - Biostar I865G-M4 Setup Manual

CHAPTER 2 : HARDWARE INSTALLATION
2.1 C
ENTRAL
Step 1: Pull the lever sideways away from the socket and then raise the
lever up to a 90-degree angle.
Step 2: Look for the white dot/cut edge. The white dot/cut edge should
point wards the lever pivot. The CPU will fit only in the correct
orientation.
Step 3: Hold the CPU down firmly, and then close the lever to complete the
installation.
Step 4: Put the CPU Fan on the CPU and buckle it. Connect the CPU FAN
power cable to the JCFAN1. This completes the installation.
2.2 FAN H
EADERS
These fan headers support cooling fans built in the computer. The fan
wiring and plug may be different according to the fan manufacturer.
Connect the fan cable to the connector while matching the black wire to
pin#1.
CPU FAN Header: JCFAN1
1
System Fan Header: JSFAN1
1
Note:
The JCFAN1 and JSFAN1 support 3-pin head connector. When
connecting with wires onto connectors, please note that the red wire is the
positive and should be connected to pin#2, and the black wire is Ground and
I865G-M4
P U (CPU)
ROCESSING NIT
Pin
1
2
JCFAN1
3
Pin
1
2
JSFAN1
3
7
Assignment
Ground
+12V
FAN RPM rate sense
Assignment
Ground
+12V
FAN RPM rate sense