Advertisement
4. HOW TO USE ADVANCED FUNCTIONS
Press this button
The unit will operate at
the biggest capacity
Turbo
Turbo
output to reach the
setting Temp. quickly.
Press this button to activate Turbo feature. It enables the unit to reach the set temperature in the shortest time.
Press it again to disable it.(Model dependent)
Press this button
Under ECO Intelligent eye mode, with the built-in infrared sensor, the unit
ECO
can detect the people's activities in the room. In Cooling/Heating mode ,when
you are away for 30 minutes, the unit automatically lowers the frequency to
Intell-
save energy(for inverter models only). And the unit will automatically resume
ignet
operation if sensing human activity again.
Eye
Press LED button
LED
LED
Press this button to turn
on and turn off the display
on the indoor unit.
09
Press this button more than 5 seconds
5s
LED
Keep pressing this button more than 5 seconds, the
indoor unit will display the actual room temperature.
Press more than 5 seconds again will revert back to
display the setting temperature(Model dependent).
SET
SET
or
Press the SET button to enter the function setting, then press SET button or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
*
Breeze away (
)
Active clean (
)
AP mode (
)
Breeze away....
*
[ ]: Model dependent
*
Breeze Away function(
) (some units) :
This feature avoids direct air flow blowing on the body and makes you feel indulging in silky coolness.
NOTE: This feature is available under cool, Fan and Dry mode only.
Active clean function(
) (some units) :
The Active Clean Technology washes away dust, mold, and grease that may cause odors when it adheres
SET
to the heat exchanger by automatically freezing and then rapidly thawing the frost.
When this function is turned on, the indoor unit display window appears "CL", after 20 to 45 minutes, the unit
will turn off automatically and cancel CLEAN function.
FRESH/UV lamp function(
) (some units) :
When the FRESH function is initiated, both the Ionizer(if any) and UV lamp(if any) function are energized
and will help to remove pollen and impurities from the air.
Sleep function(
) (some units) :
The SLEEP function is used to decrease energy use while you sleep(and don't need
the same temperature settings to stay comfortable). This function can only be activated
via remote control. For the details, see "Sleep operation" in "USER'S MANUAL".
NOTE: The SLEEP function is not available in FAN and DRY mode.
Follow me function(
) :
The FOLLOW ME function enables the remote control to measure the temperature at its current location
and send this signal to the air conditioner every 3 minutes interval. When using AUTO, COOL or HEAT
modes, measuring ambient temperature from the remote control(instead of from the indoor unit itself) will
enable the air conditioner to optimize the temperature around you and ensure maximum comfort.
NOTE:
Press and hold Turbo button for seven seconds to start/stop memory feature of Follow Me function.
If the memory feature is activated, "
"
On
displays for 3 seconds on the screen.
If the memory feature is stopped, "
OF
"
displays for 3 seconds on the screen.
While the memory feature is activated, press the ON/OFF button, shift the mode or power failure
will not cancel the Follow me function.
AP function(
)(some units) :
Choose AP mode to do wireless network configuration. For some units, it doesn't work by pressing
the SET button. To enter the AP mode, continuously press the LED button seven times in 10 seconds.
OK
or TEMP
*
Fresh/UV (
)
Sleep(
)
Follow Me(
)
10
Advertisement
