Advertisement
10 Checking the Special Harvester
10 Checking the Special Har‐
vester
10.1
Checking the Controls
Button
► Pull the connecting cable plug out of the
socket.
► Press and release the button.
► If the button is stiff or does not jump back to its
idle position: Do not use the harvester and
contact a STIHL authorized dealer for assis‐
tance.
The button is defective.
Switching on the Harvester
► Plug in the plug of the connecting cable.
► Press and release the button.
The rakes are running.
► If 3 LEDs on the battery flash red: Pull the
connecting cable plug out of the socket and
contact a STIHL authorized dealer for assis‐
tance.
There is an error in the harvester.
► Press and release the button.
The rakes stop running after a brief delay.
► If the rakes continue to run: Pull the connect‐
ing cable plug out of the socket and contact a
STIHL authorized dealer for assistance.
The harvester is defective.
11 Operating the Special Har‐
vester
11.1
Adjusting the shaft length (SPA
140.0)
The shaft can be adjusted to different lengths to
suit the application as well as the user's height
and reach.
► Switch off the harvester and pull the connect‐
ing cable plug out of the socket.
max 45°
► Maintain an angle of no more than 45° to the
horizontal.
► Turn the clamp nut (1) a half-rotation
towards
.
0458-025-9901-A
► Adjust the shaft (2) to the required length.
► Turn the clamp nut (1) in direction as far as it
► Make sure the shaft (2) cannot be pushed in
► If the shaft can be pushed in or pulled out:
11.2
► Hold the harvester at the handle with one
► Hold the harvester firmly with your other hand
11.3
Depending on the application, you can set 3
power levels. The higher the power level, the
faster the rakes will run.
The selected power level affects the battery's
runtime. The lower the power level, the longer
the runtime.
2
1
► Push the power setting button (1) backwards
will go.
or pulled out any more.
The shaft length is properly adjusted if the
shaft (2) cannot be pushed in or pulled out any
more.
Twist the clamp nut in direction
shaft cannot be pushed in or pulled out any
more.
Holding and Controlling the
Harvester
hand – wrap your thumb around the handle.
on the shaft – wrap your thumb around the
shaft.
Setting the Power Level
1
and allow it to spring back.
This selects the next power level. After the
third performance level, it starts again with the
first performance level.
English
until the
27
Advertisement
Chapters
