Table of Contents
Advertisement
aerosols, dirt, rust, scale and liquid water. If contaminated, the desiccant material will lose its adsorption proprieties.
During normal operation, the desiccant will release a small amount of dust (as fine powder) that is particularly abrasive
and can be extremely damaging to downstream components and users.
For this reason, it is highly recommended that the dryer is equipped with two high-efficiency CLEARPOINT® filters:
+ 0.01 micron filtration grade coalescing pre-filter with differential pressure gauge and either a float drain or
BEKOMAT®
+ 1.0 micron filtration grade particulate post-filter (differential gauge optional) and with a manual drain.
3.4 Flow Diagram
Number
1
Inlet Valve (Normally Open)
2
Purge Exhaust Valve (Normally Closed)
3
Exhaust Silencer
4
Outlet Check Valves
5
Pressure Relief Valve
6
Purge Control Valve
7
Optional BEKOMAT Zero Loss Drain
DRYPOINT® XC Series Heatless Regenerated Dryers: IOM10003
Name
Number
8
Solenoid Block
9
Pilot Air Filter and Regulator
10
Vessel Pressure Gauge
11
Dew Point Sensor (Optional)
12
Energy Management System %RH
13
Pre-filter with Float Drain
14
Post-filter with Manual Drain
(Rev.I)
Name
9
Advertisement
Table of Contents
