Components - MULTIQUIP WHITEMAN Series Operation Manual

15
13
16
18
2
14
Figure 5 and Figure 6 show the location of the basic
components of a 10-foot WSHE/A screed. The function of
each component is described below.
1. rear (bull Float) blade — 2-1/2" high x 3" wide blade,
constructed of 10-gauge galvanized steel.
2. Front blades — two 2-1/2" high x 2" wide blades,
constructed of 10-gauge galvanized steel.
3. Truss Frame — Available in four lengths: 2-1/2 ft., 5 ft.,
7-1/2 ft. and 10 ft. (two 5 ft. sections illustrated above).
Each frame section features a heavy-duty schedule 80
top pipe for structural integrity.
4. Turnbuckle — Connects two truss sections together.
Fine threads allow controlled adjustment for slight
crown or invert configurations.
WSHe/a vibraTory TruSS Screed • operaTion manual — rev. #0 (05/22/12) — page 21
7
8
3
6
1
Figure 5. WSHE Components
4
9
12
5
5. blade connector — Connects two blades together.
Bolt-on blade design allows for easy replacement of
worn or damaged blades.
6. rotating eccentric Shaft — Produces over 8000
VPM, built of 3/4" diameter, high strength steel.
7. pillow block bearings — Support rotating shaft.
8. eccentric Weights — Bolted onto rotating shaft to
produce vibration.
9. engine — Honda GX270 or GX340 engine drives the
rotating shaft.
10. guard Tube — Covers the rotating shaft to prevent
equipment damage and operator injury.
11. Tube mounts — Secure guard tubes to the truss frame.
12. belt guard — Covers the rotating V-belt to prevent
operator injury.

cOMpOnentS

13
15
17
3
11
11 10