Table of Contents
Advertisement
Install a Modular Port Adapter
8. Verify that the router is in the NSR-ready state. Use the show redundancy command as shown in the
following example:
Router#show redundancy
Thu Jun
Redundancy information for node 0/RP0/CPU0:
==========================================
Node 0/RP0/CPU0 is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Standby node in 0/RP1/CPU0 is NSR-ready
Reload and boot info
----------------------
RP reloaded Wed May 31 16:03:53 2023: 1 day, 5 hours, 48 minutes ago
Active node booted Wed May 31 16:03:53 2023: 1 day, 5 hours, 48 minutes ago
Standby node boot Wed May 31 16:04:06 2023: 1 day, 5 hours, 48 minutes ago
Standby node last went not ready Wed May 31 16:07:06 2023: 1 day, 5 hours, 45 minutes
ago
Standby node last went ready Wed May 31 16:08:53 2023: 1 day, 5 hours, 43 minutes ago
Standby node last went not NSR-ready Wed May 31 16:06:49 2023: 1 day, 5 hours, 45 minutes
Standby node last went NSR-ready Wed May 31 16:13:26 2023: 1 day, 5 hours, 39 minutes
ago
There have been 0 switch-overs since reload
Active node reload "User initiated chassis reload"
Standby node reload "User initiated chassis reload"
9. Proceed with installing an MPA.
Install a Modular Port Adapter
This section provides step-by-step instructions for installing a modular port adapter (MPA) in a Cisco 8600
Series router.
Note
Warning
To install an MPA, perform the following steps:
1. Ensure the router is in the NSR-ready state. Use the show redundancy command as shown in the following
example:
Router#show redundancy
Thu Jun
Redundancy information for node 0/RP0/CPU0:
==========================================
Node 0/RP0/CPU0 is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Standby node in 0/RP1/CPU0 is NSR-ready
Hardware Installation Guide for Cisco 8600 Series Routers
102
1 21:52:36.811 UTC
ago
After you remove the MPA from the slot, wait for 60 seconds before you reinsert an MPA.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
1 21:44:12.842 UTC
Replace Chassis Components
Advertisement
Table of Contents
