Table of Contents
Advertisement
11. Position the heat sink fan duct over the new heat sink and fan assembly. Then, press the heat sink fan
duct straight down until it snaps into position.
Figure 37. Installing the heat sink fan duct
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 76.
Replacing a memory module
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii .
The following table provides information about the memory module installation rules. The "X" mark indicates
the memory slot(s) into which the memory module(s) should be installed in different situations. The numbers
1, 2, 3, and 4 indicate the installation sequence. To locate the memory module slots, see "Parts on the
system board" on page 8 .
Memory modules
One memory module
Two memory modules
To replace a memory module, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 54.
3. Remove the front bezel. See "Replacing the front bezel" on page 54.
4. Remove the optical drive. See "Replacing the optical drive" on page 57.
5. Pivot the drive bay assembly upward. See "Pivoting the drive bay assembly upward and downward"
on page 59.
6. Locate the memory module you want to replace. The memory modules are installed in the memory slots
on the system board. See "Parts on the system board" on page 8 .
72
ThinkCentre M700 User Guide
DIMM 1
X
X
DIMM 2
X
Advertisement
Table of Contents
