Arrow Storage Products Mountaineer Series Owner's Manual & Assembly Manual page 37

Step 12: Roof Trim
You will need for this page:
SS SS
(QTY: 4) (QTY: 16+)
1
Slide Peak Cap legs under Ridge Cap and secure
Ridge Cap ends with four Small Bolts and Nuts on
each end as shown.
2 Position Left and Right Roof Trim as shown below
and secure with Small Screws. Do not fasten the
last Screw on each end. Pay close attention to
where the Left and Right Roof Trim pieces are located.
3
If you are erecting a 10'x15' (3,0 m x 4,6 m) or
larger building, install Mid Roof Trim along the re-
mainder of the roof edge. Roof Trim overlaps as
shown to the right.
4
Position the Roof Trim Caps as shown below and
secure with a Small Screw. Using your thumb
and index fi nger, overbend the bottom fl ange of the
Side Roof Trim at the corner inward enough so the right
and left Roof Trim Caps fi t onto right and left corners.
Left Roof Trim
6015
Mid Roof Trim
10620
Right Roof Trim
SB
(QTY: 8)
80017
SB
2
80017 10620
Left Trim Right Trim
Insert a Small Screw where Roof
Trim overlaps after installing.
Roof Trim Caps are positioned as shown.
SB
Mid Roof Trim
80017
Left Roof Trim
37
2 0+
6015
Mid Trim Trim Cap (L)
2
Trim Cap (R) Peak Cap
6015
10620
Right Roof Trim
10'x15' (3,0 m x 4,6 m)
building shown.
2
2