Table of Contents
Advertisement
18
www.aeg.com
With the flap in the
position DOWN:
5. Measure out the detergent and the
fabric conditioner.
6. Carefully close the detergent
dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.
10.7 Starting the programme
without the delay start
Press button Start/Pause to start the
programme.
The related indicator stops flashing and
stays on.
On the display all indicator related to the
load and to the quantity of detergent go
off.
The indicator of the phase in operation
flashes.
10.8 Starting a programme
with the delay start
1. Press button Zeitvorwahl again and
again until the display shows the
number of minutes or hours of delay.
The related indicator comes on.
2. Press button Start/Pause.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Start/Pause to start the
appliance, you can cancel or
change the set of the delay
start.
10.9 Cancelling the delay start
To cancel the delay start:
• Do not use
gelatinous or thick
liquid detergents.
• Do not put more
liquid detergent than
the limit showed in
the flap.
• Do not set the
prewash phase.
• Do not set the delay
start function.
1. Press button Start/Pause to set the
appliance to pause.
The related indicator flashes.
2. Press button Zeitvorwahl repeatedly
until the display shows .
3. Press button Start/Pause again to
start the programme immediately.
10.10 Behaviour of the
appliance
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
• The display shows the
new time value.
10.11 Cancelling a running
programme
1. Press button Auto Off to cancel the
programme and to deactivate the
appliance.
2. Press button Auto Off again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Interrupting a
programme and changing a
function
You can change only some options
before they operate.
1. Press button Start/Pause.
The related indicator flashes.
2. Change the function set.
3. Press the button Start/Pause again.
The programme continues.
Advertisement
Table of Contents
