Table of Contents
Advertisement
Fireplace Face
Bottom Trim
Riser Bar
Figure 11. Using the leveling bolts to adjust surround assembly alignment.
Leveling Bolts
The leveling bolts are used to compensate for irregular
hearth surfaces. More importantly, they also provide a
method of adjustment f0r the correct vertical (plumb)
and horizontal (level) alignment of the surround
assembly with the fireplace face and hearth.
If the Bottom Trim section is to be installed with the
Surround assembly, you must use the leveling bolts to
plumb the front-to-back pitch of the firebox. See fig. 11.
Install the leveling bolts all the way into either the
Riser Bar or the Firebox.
Install the Firebox
1. If appropriate to your installation (see page 8),
position the riser bar centered within the fireplace
as shown in fig. 12. The forward ends of the Riser
Bar should be aligned within 1/2 inch of the
fireplace face.
2. With the help of an assistant, slide the Firebox
into the fireplace cavity. If using the Riser Bar, the
Firebox must be engaged with the Riser by means
of the Locking Pin included in the hardware bag.
Pull the Left Blower forward out of the way to
access the Locking Pin hole in the firebox floor.
See fig. 12. When the front edge to the firebox
is aligned with the front edge of the Riser, the
Locking Pin hole will be aligned with the slot in
the top of the Riser Bar cross-member. Insert the
Locking Pin and pull the firebox out slightly proud
of the fireplace face to facilitate attaching the
surround panels. Relocate the blower.
3. Secure the flue connector to the firebox flue collar
using three 1/4" x 3/4" self-tapping screws.
Surround assembly out-of-plumb
with fireplace face
Jøtul C 350 Winterport 138376_Rev_R 7/18
Surround assembly is plumb with
fireplace face
Figure 12. Riser Bar placement and Locking Pin.
Levelling Bolts
Locking Pin Slot
Surround
Bracket
L
Riser Bar
Locking Pin
Hole
Leveling
bolt head
R
11
Advertisement
Table of Contents
